Instructions for Use of CAB system
Finishing Attachments
After composite resin attachments have been placed and fully cured, identify any excess by visual inspection or by the use of ultraviolet LED.
Remove the blue CAB bur from the package with tweezers and place it into a high-speed turbine using finger pressure only. Gently wipe away the excess composite, trying to avoid touching the body of the attachment.
Once the excess has been removed, change to the red bur and polish the attachment-enamel interface.
Then swap to the super-fine yellow band bur and polish the enamel to a high lustre.
Removing attachments
Remove the blue CAB bur from the package with tweezers and place it into a high-speed turbine using finger pressure only. Gently wipe away the body of the composite attachment, until you get close to the enamel.
Once the body of the attachment has been removed, change to the red bur and polish the attachment completely away, back to the enamel surface.
Then swap to the super-fine yellow band bur and polish the enamel to a high lustre. The application of topical fluoride is highly recommended.